English
SLO-30VB
Slot type photoelectric sensor
Not affected by external light interference, with
built-in micro photoelectric sensor with wire amplifier
Main features
◼︎ Variable dimming type unaffected by external light interference
◼︎ Bring in light display light
◼︎ High speed response time: 1ms or 300ms, depending on the specific model
◼︎ Detection distance:0 ... 30 mm
U-shaped
Detection distance
IP67 NEMA6
Data sheet
Slot width
30mm×45mm，Beam distance from outer edge 10mm
Voltage and current
10~30VDC, 30mA
Power protection circuit
Protected against reverse polarity and transient voltages
Output circuit structure
Bipolar
NPN and PNP
Output capacity
Each output is 150mA
Output protection circuit
Prevent erroneous pulses during power on and output short circuits
Output response time
1ms or 300ms, depending on specific model
Repeatability
250ms or 75ms, depending on specific model
Adjustability
Non adjustable
Pilot lamp
Green：Power on/off
Yellow：Signal condition indicator light
Material quality
Structure：ABS plastic/polycarbonate cool
Lens：Acrylic organic glass
Environmental limitations
IP67 NEMA6
Anti-interference ability
Illumination of the receiving surface:
Incandescent lamp below 3000lx
Sunlight below 10000 lx
Connect
2 m (6.5') 5-conductor PVC-jacketed attached cable.
Working conditions
Temperature：-20~+60℃
Maximum relative humidity：90%，50℃ (without condensation)
Insulation resistance
20MΩ (500VDC megohmmeter) between the overall conductor and the housing
Withstand voltage
AC1000V 50/60Hz 1min between the overall conductor and the housing
Vibration (durable)
Up and down amplitudes of 1.5mm at 10~55Hz for 2h in X, Y, and Z directions
Typical applications
Gear tooth detection
Edge detection
Encoding reading
- All
- Manuals
- Drawing
- Certifications
- Software
SUMMIT ELECTRIC CO.,LTD | |
| No.101, Lane 520, Tongning Road, Jiangbei Investment Venture Park, Ningbo, China |
| Service Hotline：400 606 4800 Sale：+86 13486418136 |
| |
